and back the fluorescent colour with white RC Car Colour. While spraying you must absolutely make sure to apply only very light coats. Fluorescent colours appear not to cover as well as normal colours.Special instructions for fluorescent colours
#Blue green software
After use, turn the can upside down and spray for 2 sec. The BGD is developing a range of leading edge software tools to help optimise the design of blue green infrastructure installations.Allow the paint to dry for 5 minutes before removing the masking film and applying the next coat.The final result is obtained after 2 to 3 coats.
Always spray one very light coat at a time to avoid bleeding. The covering capacity of RC Car Colours varies slightly from one colour to the next.While spraying make even cross movements with the can. Before use, shake the can vigorously for approx.Always check to make sure that the surfaces are dry and free of dust before painting!.First paint the dark and then the light colours so as to prevent the dark colours from shining through the lighter ones.Do not remove this protective foil until the paints has dried! Mask all areas that are not to be painted, by using masking film or masking tape. Many bodies have a transparent protective foil on the outside. Blue-green algae are not algae but a type of bacteria (called cyanobacteria) that are present in our lakes and rivers.Cut out the body and sand the cut edges.Remove any dirt particles from the surface to be painted. The special solvent used etches the surface, allowing the paint to bond permanently with the polycarbonate.īefore you begin.
RC Car Colours have been specially developed for the painting of Polycarbonate bodies. Ready to use, quick drying, fuel resitant light weight paint for racing, If wished for up-to 15 gr less weight on a 1/10 scale race body, compard to pre-painted or water based coloured bodies (lower cenre of gravity)
0 kommentar(er)
